LILAC Creteseal (10L)

රු8,685.00

LILAC CRETESEAL is an acrylic based Polymer modified cementitious composite coating system. Combines a tuff hard-wearing surface with waterproofing.

Category:

DESCRIPTION

LILAC CRETESEAL is an acrylic based Polymer modified cementitious composite coating system.

USES

Polymer in conjunction with cement provides properties to combat the shortcomings of cement particularly its poor adhesion properties, low impact strength, low flexural strength and thin section fragility. 

UNIQUE FEATURES

Combines a tuff hard-wearing surface with waterproofing. Allows trapped vapors to escape thus preventing peeling and blister formation.

OTHER FEATURES

Can be applied in uniform thickness to horizontal and vertical surfaces.
Develops excellent bond to most building materials.
Prevents salt penetration into concrete.
Is not effected by ultraviolet light or by chemicals ranging from mild acids to strong alkalies.
Is highly durable in continuous wet condition.
Is non-flammable and does not give off toxic gases, when exposed to fire.
Will not rot or corrode.
Most properties improve with age.
Is not harmful to the health or workmen. 

CRETESEAL POLYMER IS IDEALLY SUITED FOR:

Waterproofing of basement, terraces, swimming pools, salt attack etc.
General concrete repairs
Protection of concrete against corrosion, salt attack etc.

APPLICATION

Surface Preparation  : Prior to application of CREATSEAL, surface must be prepared as mentioned below to avoid failure: The surface shall be cleaned to remove all dust, foreign matters, loose materials or any deposits of contamination which could affect the bond between the surface and the CREATSEAL coating. This can be done by scarifying, grinding, water blasting, sand blasting, acid washing or any other approved method. New flat surface like sub-base concrete shall be made reasonably smooth so as not to impede the application of DREATESEAL coating and to avoid sharp projection. All concrete surfaces shall be thoroughly pre-wetted for at least one hour prior to the application of CRETESEAL coating by pouring water on flat surface or by vigorously spraying water on vertical/inclined surfaces. When placing CRETESEAL Coating, water should be removed so that surface is only damp. In no case there should be standing water or a shiny wet surface.

Depressions are filled and leveled using CRETESEAL fillers. For filler, the mixing ratio is 1 kg cement:1.5 by silica sand and 0.52 kg LILAC CRETESEAL. 

HEALTH & SAFETY                  Non-toxic, Non-flammable, Eco-friendly.

Reviews

There are no reviews yet.

Be the first to review “LILAC Creteseal (10L)”

Your email address will not be published. Required fields are marked *

Call Now ButtonScroll Up